Hirose wfl rf cable assemblies
You are here: Home » RF Cable Assemblies » Hirose W.FL connector
About Hirose W.FL series
GradConn offer a selection of cable assemblies including the Hirose W.FL (W.FL-LP-040) connector. The most popular choices are for the opposite end of the Hirose RF cable assembly are SMA female or FME male bulkhead connectors. This allows customers to mount the SMA or FME interface connectors to a bulkhead with a cut out and plug in a antenna or further extension cable on the other side of the bulkhead. Find further information on the Hirose WFL connectors below:
Hirose W.FL connector features:
Mated height: 1.4mm (1.55mm max).
PCB occupied area: 3.4 sq.mm.
Light weight: Receptacle: 5.6mg. Right angle plug: 18.6mg.
High frequency transmission: Up to 6GHz. V.S.W.R.: 1.3 max., from DC to 3GHz.
Impedance (ohm): 50
Simple mating and un-mating: Tools are available from Hirose distributors.
Suitable for 20 mating cycles.
Temperature range: -40 to 90 degrees centigrade.
Centre Conductor Plating: Gold
PCB mount type: SMT
Applications: Mobile phones, Radio communications equipment, Measurement equipment, PDA, GPS, Wireless LAN, Bluetooth
As an alternative to Hirose WFL GradConn offer the I-Pex MHFIII range. The MHF3 is a high quality and economical connector is intermatable with Hirose W.FL. This means a customer can plug an I-PEX MHFIII cable assembly into a Hirose PCB connector. Customer’s should test samples to approve the use of I-Pex, however GradConn have many satisfied customers after swapping from Hirose.
Visit the Hirose website for more information.
For further information about GradConn’s Hirose W.FL cable assembly offering contact GradConn
Specifications are subject to change without notice. Please consult the manufacturer for the most up to data information.
Hirose W.FL Cable Assemblies
|
CABLE 040 RF
RF Cable Assembly Ipex economical alternative: CABLE 039 RF
|
 |
|
  |
||
