Hirose hfl rf cable assemblies
About Hirose H.FL series
GradConn offer a selection of cable assemblies including the Hirose H.FL connector. GradConn use original Hirose crimp tooling. The most popular choices are for the opposite end of the Hirose RF cable assembly are SMA female or FME male bulkhead connectors. This allows customers to mount the SMA or FME interface connectors to a bulkhead with a cut out and plug in an antenna or further extension cable on the other side of the bulkhead. Find further information on Hirose HFL connectors below:
Hirose H.FL connector features:
Mated height: 3.00mm.
High frequency transmission: Up to 6GHz. V.S.W.R.: 1.3 max., from DC to 3GHz.
Impedance (ohm): 50, 75.
Simple mating and un-mating: Tools are available from Hirose distributors.
Temperature range: -40 to +90° C.
Centre Conductor Plating: Gold
PCB mount type: SMT
Applications: Mobile phones, Radio communications equipment, Measurement equipment, GPS, TV tuner of PC.
Visit the Hirose website for more information.
Specifications are subject to change without notice. Please consult the manufacturer for the most up to data information.
Hirose H.FL Cable Assemblies
Hirose H.FL to SMA straight Bulkhead Jack (Female with threaded nut)
Length: 50mm upwards
Cable Diameter: 1.48mm ø MIT black cable
Working Frequency Range: DC to 3GHz
Lead time: 4 weeks
Hirose H.FL to stripped end OR tinned centre conductor and copper wire soldered to braid/shield allows solder to PCB
Hirose Part Number: H.FL-LP
Length: 25-400mm
Cable Diameter: 1.32mm ø black cable
Working Frequency Range: Information not available, contact GradConn to discuss
Lead time: 5 weeks
Information on stripped and tinned cable
Hirose HFL to SMA right angle plug
Hirose Part Number: H.FL-LP
SMA part number: C01BA3F178008C
Length: 25-400mm
Cable Diameter: 1.48mm ø black cable
Working Frequency Range: DC to 3GHz
Lead time: 5 weeks
